I will pay for the following article The Properties and Features of the Wood Material. The work is to be 5 pages with three to five sources, with in-text citations and a reference page.

I will pay for the following article The Properties and Features of the Wood Material. The work is to be 5 pages with three to five sources, with in-text citations and a reference page. The primary focus for undertaking this lab experiment was the fact that it is very essential to be conversant with various wood properties since it is a very vital construction element. On the other hand, wood is regarded as an anisotropic component. It is due to the fact that. its features tend to vary with respect to the wood’s grain structure. It hence necessitates the utilization of various elastic constants. The variation often occurs on the basis of Radial, Longitudinal, as well as the Tangential faces as shown below:The main objective of undertaking this lab experiment was to assist in providing a better understanding of the properties and features of the wood material. To ascertain this ultimate aim, the experiment was done using four primary samples. It was based on the fact that. two of these samples were used for testing the compressive strength in such a manner that the load was aligned in a parallel position. The other two were also subsequently performed in such a manner that the load was aligned in a perpendicular position to the grains. This set-up was generally meant for enabling for computation of the maximum compression strength as well as the ultimate modulus of elasticity. The basic consideration was that. they all set the basis on both parallel and perpendicularly aligned set-ups. The experimental procedure also enabled for identification of the general influence of both the wood type, failure mechanism, as well as the wood direction (New York Lumber Trade Association, 1923).In this segment, the lab experiment started by first taking the measurements of the width, length, as well as height of the beam specimen. After recording these dimensions, the beam’s mid-point was then marked alongside the member’s length.&nbsp.